MAX1238MEEE+T【PDF 5/22 页】IC ADC 12BIT SERIAL 16-QSOP

收藏本站

您好，
买卖IC网欢迎您。
请登录
免费注册

买卖IC网

Sheet目录2008

1页 2页 3页 4页 [5页]6页 7页 8页 9页

Configuration/Setup Bytes (Write Cycle)

A write cycle begins with the bus master issuing a

START condition followed by seven address bits (Figure

7) and a write bit (R/W = 0). If the address byte is suc-

cessfully received, the MAX1236–MAX1239 (slave)

issues an acknowledge. The master then writes to the

slave. The slave recognizes the received byte as the

set-up byte (Table 1) if the most significant bit (MSB) is

1. If the MSB is 0, the slave recognizes that byte as the

configuration byte (Table 2). The master can write either

one or two bytes to the slave in any order (setup byte,

then configuration byte; configuration byte, then setup

byte; setup byte or configuration byte only; Figure 9). If

the slave receives a byte successfully, it issues an

acknowledge. The master ends the write cycle by issu-

ing a STOP condition or a repeated START condition.

When operating in HS-mode, a STOP condition returns

the bus into F/S-mode (see the

HS-Mode section).

MAX1236–MAX1239

2.7V to 3.6V and 4.5V to 5.5V, Low-Power,

4-/12-Channel, 2-Wire Serial, 12-Bit ADCs

______________________________________________________________________________________

B. TWO-BYTE WRITE CYCLE

SLAVE TO MASTER

MASTER TO SLAVE

SLAVE ADDRESS

71 1

SETUP OR

CONFIGURATION BYTE

SETUP OR

CONFIGURATION BYTE

P or Sr

MSB DETERMINES WHETHER

SETUP OR CONFIGURATION BYTE

SLAVE ADDRESS

71 1

SETUP OR

CONFIGURATION BYTE

P or Sr

MSB DETERMINES WHETHER

SETUP OR CONFIGURATION BYTE

A. ONE-BYTE WRITE CYCLE

NUMBER OF BITS

Figure 9. Write Cycle

BIT 7

(MSB)

BIT 6

BIT 5

BIT 4

BIT 3

BIT 2

BIT 1

BIT 0

(LSB)

REG

SEL2

SEL1

SEL0

CLK

BIP/UNI

RST

BIT

NAME

DESCRIPTION

REG

SEL2

SEL1

SEL0

Three bits select the reference voltage and the state of AIN_/REF (Table 6). Default to 000 at

power-up.

CLK

1 = external clock, 0 = internal clock. Default to 0 at power-up.

BIP/UNI

1 = bipolar, 0 = unipolar. Default to 0 at power-up (see the Unipolar/Bipolar section).

RST

1= no action, 0 = resets the configuration register to default. Setup register remains unchanged.

Don’t care, can be set to 1 or 0.

Table 1. Setup Byte Format

发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

*型号	*数量	厂商	批号	封装

添加更多采购

采购需求

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

我的联系方式